Extinguishing system Handle - Scale 1:18 printed in resin 3DP technology
Warning: Last items in stock!
INSTRUCTIONS FOR HANDLE USE:
1º Paint the corresponding color of each part of the piece.
2º Drill in the correct place on the model with a precision drill or similar, and place the corresponding decal.
3º Once the paint dries, we cut the switch to separate it from its base, and with a little glue we put it in its correct place.
INSTRUCTIONS FOR USE:
1º Cut close to the drawing without cutting it.
2º Dip the decal in water for 3-5 seconds and let it rest on an absorbent paper for about 25-30 seconds. Afterwards, the decal will detach easily from the support.
3º Manipulate it as little as possible, it will be placed in its place, and helped by a brush we will adapt it.
4º Dry the rest of the water with an absorbent paper.
5º Apply Micro Sol and / or Micro Set according to need and let dry. Finally, apply a light coat of varnish as deemed appropriate.